Installation

Artificial Grass Installation


There are no warranties regarding this installation information nor any results guaranteed by using the installation information.

Material : spade, hand roller or vibrating plate, a sharp Stanley knife, large pair of sharp scissors, a mixer to mix the bi-component adhesive, stiff brush, hammer, stainless nails, geo-textile, spatula, rake, stainless screws.

Before Start

Work out the lengths and widths you require. Lay out the area where to install the artificial grass.

Ground Preparation for gardens

  • Remove all vegetation and rocks, down to the bare earth (pic.1) (pic.2)
  • A sub base of sand is installed. This base should be porous.
  • Spread, level and compact the sub base with a hand roller or vibrating plate (pic.3).
  • During dry conditions wet the sub base a day before the installation ( pic.4).
  • Nail a geo-textile weed barrier to the base (pic.5)
  • In some certain circumstances you may need to use the wooden border.

Ground Preparation on existing hard surfaces

  • Remove surface imperfections
  • Thoroughly clean to remove all dirt, paint, grease that will prevent good adhesion

Installation on Gardens

Cut

  • The rolls are laid out. As all rolls have a directional pile, ensure that all rolls are laid out in the same direction
  • Cut carefully in the backing of the artificial grass and trim (pic.6).
  • Adjacent rolls should be laid together ensuring that straight cut edges can be butted close together. Butt both surfaces together, ensuring the pile is running in the same direction (pic.7).
  • The edges are then folded back (pic.8)

Seaming tape

  • The seaming tape is used to put the rolls together. Unroll the seaming tape along the
  • seam line, ensuring equal tape laid centrally along the seam (pic.9)*
  • Before applying the adhesive, fix the seaming tape to the sub base with stainless nails.*

Adhesive

  • Mix the bi-component adhesive with a mixer
  • Apply the adhesive with a spatula to the top surface of the seaming tape. (pic.10)
  • The edges of the artificial grass are now folded back and pressed down. Match the
  • directional pile of the rolls. (pic.11)

 

Borders

  • Fix with stainless screws on wooden beams (treated to prevent moisture) or with
  • stainless nails in the sub base.

Brush

  • Brush the piles. (pic.12)

Brush in Sand

  • Sweep 1/2 bag (12.5kg) of dry kiln sand per square metre after laying the grass to weigh to grass down and stand the pile of grass up.

Installation on existing hard surfaces

  • Lay out the rolls
  • Rolls can be loose laid or fixed with a spots of outdoor adhesive or with
  • double-sided adhesive tape.
  • Brush the piles.

 

Copyrights © 2012-2019 Suqian Easy Decorate Carpet Co., Ltd。 All Right Reserved. 人造草坪

ADD:NO.185 JINJIHU ROAD, SUQIAN ECONOMIC ZONE, JIANGSU, CHINA

TEL.:+86-527-84568339 FAX:+86-527-84568256 Mobile:+86-13951598934